View categories >>

Chipper Docking Feed Table

Chipper-Docking-Feed-Table-1 Chipper-Docking-Feed-Table-2

I had the machine shop fabricate an in feed trough for the New Jenz chipper. You back the chipper into the docking area then set up to start working.
The trough is long enough to handle most full length trees plus the cut up lengths. When loading the trough just make sure one end is on the chipper intake unless you want to pull them in with the chipper boom. This docking station is made to keep the chipper from bouncing around which keeps the output chute in a position to keep unloading.
This version is placeable.
This should be placed on level ground.

Authors: JohnDeere1952, CGTextures


Leave a Reply

Your email address will not be published.

Human Verification: In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.